IGNIZI ASPIRAZI Installation Guide
This guide will take you through all the steps required to transfer from the standard OEM key to your new custom Lamborghini key.
Take note before you begin
- It is recommended that you acquire a new CR2032 battery before installation.
- Ensure you are in a clean and dry working environment.
- Do not over-tighten screws.
- The paint is susceptible to damage due to scratching and impacts.
Please be careful with your new key. - ASPIRAZI is not waterproof. Keep your key away from rain and moisture.
- When venturing on long trips away from your vehicle's main storage facility, it is recommended that you take your OEM spare key with you in case of emergency.
1) Open the package
2) Remove the top layer of the packaging
3) Remove your new key from the foam support
4) Open up your new key
Using the included T6 Torx Screwdriver, undo all six screws.
5) Take your OEM key and remove the spare key
Release the spare key by pressing down on the silver button and pulling.
6) Remove the battery tray
Release the battery tray by pressing down and pulling back on the section circled in red.
7) Install the battery into the new key
Insert a new or the exiting battery into the designated area inside the key.
8) Remove the OEM electronics
Locate the left battery retention arm (circled) inside the OEM enclosure. Using the included pliers, gently grab and pull to release the OEM circuit board.
9) Install the OEM electronics inside your custom Lamborghini key
10) Re-assemble your new key
Replace the cap and screws. We recommend fastening the screws in an criss-cross pattern to allow for a more balanced distribution of clamping force.
11) Re-assemble the OEM key
Place the white L-shaped part back inside the OEM key. Re-assemble the key and store it in an easy to find place for safekeeping.
